Enroll, delete, or reset a Zooz ZEN77 800LR In-Wall Switch
The Zooz ZEN77 800LR In-Wall Switch can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a Zooz ZEN77 800LR In-Wall Switch, see Zooz ZEN77 800LR In-Wall Switch - Installation Guide.
To enroll a Zooz ZEN77 800LR In-Wall Switch:
As a SmartStart/Long Range (LR) device:
It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices). This method also allows the device to utilize Z-Wave Long Range.
For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.
For more information about enrolling as a Z-Wave LR device, see Add a Z-Wave Long Range (Z-Wave LR) device.
As an S2 device:
If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.
For information about this process, see Add an S2-encrypted Z-Wave device.
As an S0 device:
If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.
- Place the Z-Wave controller into Add Mode.
- Press the top paddle quickly three times.
- The LED will turn green once successfully enrolled.
To delete a Zooz ZEN77 800LR In-Wall Switch:
- Place the Z-Wave controller into Delete Mode.
- Press the top paddle quickly three times.
- The LED will turn green once successfully removed.
To reset a Zooz ZEN77 800LR In-Wall Switch:
- Press and hold the bottom paddle for 10 seconds until the LED indicator starts blinking.
- Release the paddle and immediately press the lower paddle 5 times.
- The LED will blink blue, then turn red to indicate a successful reset.