Zooz ZEN76 800LR Paddle Switch
Quick facts
| Device Image |  |
|---|---|
| Manufacturer | Zooz |
| Power Requirements | 120 VAC, 60 Hz |
| Maximum Load | 8 A, 150 W LED/CFL, 600 W incandescent, 960 W resistive (DON’T use with tube lights, fans, or receptacles) |
| Dimming | Incompatible |
| Z-Wave Security 2 (S2) | Compatible |
| Z-Wave SmartStart | Compatible |
| Z-Wave Long Range (LR) | Compatible |
The Zooz ZEN76 800LR Paddle Switch can be enrolled in or removed from a Z-Wave network by following the instructions below.
For more information about installation, see the manufacturer's Zooz ZEN76-800LR Paddle Switch - Installation Guide.
Enroll a Zooz ZEN76
For more information about adding Z-Wave devices, see Add Z-Wave devices.
To trigger the Zooz ZEN76 for enrollment using Add Mode (S0):
- Place the Z-Wave controller into Add Mode.
- Tap the upper paddle 3 times quickly.
- The blue LED will blink blue to signal communication.
- The green LED will turn on for 3 seconds when the device is successfully added to the Z-Wave® network. The LED will turn red for 3 seconds if the pairing attempt fails.
To delete a Zooz ZEN76:
- Place the Z-Wave controller into Delete Mode.
- Tap the lower paddle 3 times quickly.
- The blue LED will blink blue to signal communication.
- The green LED will turn on for 3 seconds when the device is successfully deleted from the Z-Wave controller.
To reset a Zooz ZEN76:
- Press and hold the lower paddle for 10 seconds until the LED starts blinking.
- Release the paddle, and immediately after tap the lower paddle 5 times to complete the reset.
- The LED will blink blue 3 times and turn red for 3 seconds to confirm a successful reset.
Troubleshooting