Enroll, delete, or reset a Zipato RGBW Light Bulb (Gen 2)
The Zipato RGBW Light Bulb (Gen 2) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a Zipato RGBW Light Bulb (Gen 2), see Zipato RGBW Light Bulb (Gen 2) - Installation Guide.
To enroll the Zipato RGBW Light Bulb (Gen 2) into a Z-Wave network:
- Place the Z-Wave controller into Add Mode.
- Apply power to the RGBW Light Bulb to turn it ON.
- The bulb will flash once if it has been successfully enrolled.
To delete the Zipato RGBW Light Bulb (Gen 2) from a Z-Wave network:
- Place the Z-Wave controller into Delete Mode.
- Apply power to the RGBW Light Bulb to turn it ON.
- The bulb will flash once if it has been successfully deleted.
To manually reset the Zipato RGBW Light Bulb (Gen 2):
- Toggle the RGBW Light Bulb from ON to OFF six times in intervals of 0.5 to 2 seconds.
- After the sixth toggle, the bulb will flash twice to indicate a successful reset.