Enroll, delete, or reset a Schneider Electric Z-Wave Dimmer (SQR22102WHZ)
The Schneider Electric Z-Wave Dimmer (SQR22102WHZ) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a Schneider Electric Z-Wave Dimmer (SQR22102WHZ), see Schneider Electric Z-Wave Dimmer (SQR22102WHZ) - Installation Guide.
To enroll a Schneider Electric Z-Wave Dimmer (SQR22102WHZ) into a Z-Wave network:
As a SmartStart device:
It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).
For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.
As an S2 device:
If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.
For information about this process, see Add an S2-encrypted Z-Wave device.
As an S0 device:
If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.
- Place the Z-Wave controller into Add Mode.
- Quickly press either paddle three times within 1.5 seconds.
To delete a Schneider Electric Z-Wave Dimmer (SQR22102WHZ) from a Z-Wave network:
- Place the Z-Wave controller into Delete Mode.
- Quickly press either paddle three times within 1.5 seconds.
To reset a Schneider Electric Z-Wave Dimmer (SQR22102WHZ):
- Press and hold the Reset button until the blue LED flashes five times within 1 second (about 20 seconds).