Enroll, delete, or reset a Shelly Wave Pro 1PM

As a SmartStart device:

It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).

For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.

As an S2 device:

If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.

For information about this process, see Add an S2-encrypted Z-Wave device.

As an S0 device:

If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.

Using the S button:  

1. Place the Z-Wave controller into Delete Mode.
2. Press and hold the S button until the LED turns solid blue. 
3. Quickly release and then press and hold the S button on the device until the blue LED starts blinking in mode 3. Then release the S button to initiate learn mode. 
4. The blue LED will start flashing in Mode 1 to indicate a successful deletion.

Using the switch/push button:   

1. Plug in the device and verify the blue LED is flashing.
2. Place the Z-Wave controller into Add Mode.
3. Toggle the switch/push button three times within 3 seconds. The blue LED will flash during this process.
4. The blue LED will start flashing in Mode 1 when the device is successfully deleted.

Using the S button:   

1. Press and hold the S button until the LED turns solid blue.
2. Press the S button several times until the LED turns solid red.
3. Press and hold the S button until the red LED begins flashing in Mode 3. Release to begin the factory reset. 
4. The LEDs will flash multiple colors before the blue LED 1 will flash in mode 1 to indicate a successful reset. 

Using the switch/push button:   

1. Plug in the device. 
2. Toggle the switch on five times within 3 seconds. 
3. The LEDs will flash multiple colors before the blue LED 1 will flash in mode 1 to indicate a successful reset.