Enroll, delete, or reset a Shelly Qubino Wave Pro 1

As a SmartStart device

It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).

For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.

As an S2 device

If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.

For information about this process, see Add an S2-encrypted Z-Wave device.

As an S0 device:

If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device using an attached light switch or using the S button. 

To reset the Shelly Qubino Wave Pro 1 using the switch/power button: 

1. Toggle the switch/power button five times within 3 seconds. The green LED will flash, followed by blue and red alternating in a pattern. 
2. The blue LED will begin flashing once successfully reset. 

To reset the Shelly Qubino Wave Pro 1 using the S button: 

1. Press and hold the S button until the LED turns solid blue. 
2. Press the S button multiple times until the LED turns red.
3. Press and hold the S button again until the LED begins flashing, then release.
4. The blue LED will begin flashing once successfully reset.