Enroll, delete, or reset a Shelly Qubino Wave Plug
The Shelly Qubino Wave Plug can be enrolled into or deleted from a Z-Wave network following the instructions below.
To enroll a Shelly Qubino Wave Plug:
As a SmartStart device:
It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).
For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.
As an S2 device:
If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.
For information about this process, see Add an S2-encrypted Z-Wave device.
As an S0 device:
If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.
- Place the Z-Wave controller into Add Mode.
- Press and hold the button for about 2 seconds until the LED turns solid blue, then release.
Note: If the LED is already solid blue, no change will be observed until the button is released. - Press and hold the button for about 2 seconds until the LED rapidly flashes blue, then release.
- The LED will flash blue during the add process.
To delete a Shelly Qubino Wave Plug:
- Place the Z-Wave controller into Delete Mode.
- Press and hold the button for about 2 seconds until the LED turns solid blue, then release.
Note: If the LED is already solid blue, no change will be observed until the button is released. - Press and hold the button for about 2 seconds until the LED rapidly flashes blue, then release.
- The LED will flash blue during the delete process.
To reset a Shelly Qubino Wave Plug:
- Press and hold the button for about 2 seconds until the LED turns solid blue, then release.
Note: If the LED is already solid blue, no change will be observed until the button is released. - Press and release the button. The LED will turn solid red.
- Press and hold the button for about 2 seconds until the LED rapidly flashes red, then release.
- The LED will turn solid violet while resetting, and then slowly flash blue.
Troubleshooting