Shelly Qubino Wave 1

If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled as an S0 device.

1. Verify the Wave 1 Relay is connected to power.
2. Place the Z-Wave controller into Add Mode.
3. Trigger the Wave 1 Relay for inclusion:
   • Using an attached light switch:
     1. Toggle the attached switch on and off three times within 3 seconds.
   • Using the S button:
     1. Press and hold the S button until the LED turns solid blue.
     2. Release, then press and hold the S button for at least 2 seconds.
     3. Release the S button when the LED begins rapidly flashing (0.1s on, 0.1s off).
4. The LED will blink (0.5s on, 0.5s off) during the inclusion process.
5. The attached load will be toggled on and off twice when the Wave 1 Relay is successfully added to the Z-Wave network.