Enroll, delete, or reset a Qolsys IQ Z-Wave Outlet (QZ2130-840)
The Qolsys IQ Z-Wave Outlet (QZ2130-840) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a Qolsys IQ Z-Wave Outlet (QZ2130-840), see Qolsys IQ Z-Wave Outlet (QZ2130-840) - Installation Guide.
To enroll a Qolsys IQ Z-Wave Outlet (QZ2130-840) into a Z-Wave network:
- Place the Z-Wave controller into Add Mode.
- Press and release the program button.
- Verify that the device shows up on the Alarm.com customer website or Alarm.com app and responds to commands to turn the Qolsys IQ Z-Wave Outlet on/off.
To delete a Qolsys IQ Z-Wave Outlet (QZ2130-840) from a Z-Wave network:
- Place the Z-Wave controller into Delete Mode.
- Press and release the program button.
- The controller should indicate that the device was removed successfully.
To reset a Qolsys IQ Z-Wave Outlet (QZ2130-840):
- Unplug the IQ Outlet from the AC outlet as well as the power plugs of the lighting from the module (if plugged in).
- Press and hold the program button.
- Plug the IQ Outlet back into the AC outlet with the button pressed. After 3 seconds, release the button.
- If you see the button blink, that means that IQ Outlet has been reset successfully.