Enroll, delete, or reset a Qolsys IQ Plug-In Dimmer (QZ2141-840)
The Qolsys IQ Plug-In Dimmer (QZ2141-840) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a Qolsys IQ Plug-In Dimmer (QZ2141-840), see Qolsys IQ Plug-In Dimmer (QZ2141-840) - Installation Guide.
To enroll a Qolsys IQ Plug-In Dimmer (QZ2141-840) into a Z-Wave network:
As a SmartStart device:
It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).
For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.
As an S2 device:
If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.
For information about this process, see Add an S2-encrypted Z-Wave device.
As an S0 device:
If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.
- Plug in the Qolsys IQ Plug-In Dimmer (QZ2141-840) in the desired location.
- Place the Z-Wave controller into Add Mode.
- Press the button on the top of the dimmer.
To delete a Qolsys IQ Plug-In Dimmer (QZ2141-840) from a Z-Wave network:
- Place the Z-Wave controller into Delete Mode.
- Press the button on the top of the dimmer.
To reset a Qolsys IQ Plug-In Dimmer (QZ2141-840):
- Unplug the Qolsys IQ Plug-In Dimmer (QZ2141-840) from the AC outlet and also unplug the power plug of the appliance from the dimmer (if plugged in).
- Press and hold the button on the top of the dimmer.
- Plug the dimmer back into the AC outlet with the button pressed.
- After 3 seconds, release the button. The LED will blink to indicate that the PD700 has been reset successfully.