IQ SmartPlug PG
The IQ Smart Plug PG enables you to control your electrical appliances remotely through the Alarm.com app or a compatible IQ panel. For more information about PowerG devices, see Manage PowerG automation devices on a Qolsys panel.
For more information about installation, see the manufacturer's IQ Smart Plug PG - Installation Guide.
Quick facts
| Device image | |
|---|---|
| Manufacturer | Qolsys |
| Power Requirements | 110-230 VAC 50/60 Hz |
| Maximum Load | 15 Amps |
| Dimming | No |
| Communication Protocol | PowerG |
To enroll an IQ Smart Plug PG:
- On the IQ Smart Plug PG, press and hold the button on the device until the orange LED lights up (~2 seconds).
- Release the button and the LED turns off. The device enters enrollment mode and the panel is notified of the PowerG device.
- Continue enrollment on the IQ control panel:
- Flick down to open the menu on the home screen, then tap Settings.
- Tap Advanced Settings.
- Enter the installer code.
- Tap Installation.
- Tap Devices.
- Tap Automation.
- Tap Auto Learn Devices.
- Trigger the PowerG device. For more information, refer to the documentation for the device in Alarm.com supported PowerG devices.
- Tap Pair.
- Allow 1-2 minutes after enrolling to allow the device to network with the panel.
- If the connection is successful, the link quality displays on the device and on the control panel.
- If the connection fails, a not enrolled status displays on the control panel.
Note: If the button remains pressed beyond the lighting time, the device returns to sleep mode.
To delete an IQ Smart Plug PG:
- On the IQ control panel, flick down to open the menu on the home screen, then tap Settings.
- Tap Advanced Settings.
- Enter the installer code.
- Tap Installation.
- Tap Devices.
- Tap Automation.
- Tap Delete Device.
- Tap the devices to be deleted.
- Tap Delete.
To reset an IQ Smart Plug PG:
- On the IQ Smart Plug PG, press and hold the button on the device until the orange LED lights up (~2 seconds).
- Briefly release, then press and hold the button again for 5 seconds until the red LED flashes three times to indicate a reset to factory default.