Enroll, delete, or reset a Leviton Smart Outlet, 700 Series (ZW15R)

As a SmartStart device:

It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).

For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.

As an S2 device:

If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.

For information about this process, see Add an S2-encrypted Z-Wave device.

As an S0 device:

If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.

1. Place the Z-Wave controller into Add Mode.
2. Press and hold the button on the device for 7 seconds. The LED on the device will turn amber.
3. Tap the button again. The LED will flash green.
4. The LED will flash green four times to indicate successful enrollment.