Enroll, delete, or reset a Jasco or GE/Enbrighten In-Wall Smart Toggle Switch (46563 or 46202)
The Jasco or GE/Enbrighten In-Wall Smart Toggle Switch 46563 or 46202 can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a Jasco or GE/Enbrighten In-Wall Smart Toggle Switch with S2 46563 or 46202, see Jasco or GE/Enbrighten In-Wall Smart Toggle Switch 46563 or 46202 - Quick Start Guide.
To enroll a Jasco or GE/Enbrighten In-Wall Smart Toggle Switch into a Z-Wave network:
As a SmartStart device:
It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).
For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.
As an S2 device:
If your Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.
For information about this process, see Add an S2-encrypted Z-Wave Device.
As an S0 device:
If your Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.
- Place the Z-Wave controller into Add Mode.
- Press up or down on the smart toggle switch.
To delete a Jasco or GE/Enbrighten In-Wall Smart Toggle Switch from a Z-Wave network:
- Place the Z-Wave controller into Delete Mode.
- Press up and release the switch toggle.
To reset a Jasco or GE/Enbrighten In-Wall Smart Toggle Switch:
- Quickly press up on the switch toggle three times, then immediately press down on the switch toggle three times.
- There will be no indication from the switch that a successful reset has occurred.