Enroll, delete, or reset a Jasco or GE/Enbrighten In-Wall Smart Paddle Switch (46562 or 46201)
The Jasco or GE/Enbrighten In-Wall Smart Paddle Switch (46562 or 46201) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a Jasco or GE/Enbrighten In-Wall Smart Paddle Switch with S2 (46562 or 46201), see Jasco or GE/Enbrighten In-Wall Smart Paddle Switch (46562 or 46201) - Quick Start Guide.
To enroll a Jasco or GE/Enbrighten In-Wall Smart Paddle Switch into a Z-Wave network:
As a SmartStart device:
It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).
For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.
As an S2 device:
If your Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.
For information about this process, see Add an S2-encrypted Z-Wave Device.
As an S0 device:
If your Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.
- Place the Z-Wave controller into Add Mode.
- Press and release either the top or bottom of the switch paddle.
To delete a Jasco or GE/Enbrighten In-Wall Smart Paddle Switch from a Z-Wave network:
- Place the Z-Wave controller into Delete Mode.
- Press and release either the top or bottom of the switch paddle.
To reset a Jasco or GE/Enbrighten In-Wall Smart Paddle Switch:
- Quickly press the top of the switch paddle three times, then immediately press the bottom of the switch paddle three times.
- The LED will flash five times to indicate a successful reset.