Enroll, delete, or reset a Jasco Pro Series Smart LED Bulb (76609)
The Jasco Pro Series Smart LED Bulb (76609) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a Jasco Pro Series Smart LED Bulb (76609), see Jasco Pro Series Smart LED Bulb (76609) - Installation Guide.
To enroll a Jasco Pro Series Smart LED Bulb (76609):
As a SmartStart device:
It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).
For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.
As an S2 device:
If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.
For information about this process, see Add an S2-encrypted Z-Wave device.
As an S0 device:
If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.
- Place the Z-Wave controller into Add Mode.
- Power the Smart Bulb off and on three times. The bulb will flash twice to indicate successful enrollment.
To delete a Jasco Pro Series Smart LED Bulb (76609):
- Place the Z-Wave controller into Delete Mode.
- Power the Smart Bulb off and on three times. The bulb will flash twice to indicate successful removal.
To reset a Jasco Pro Series Smart LED Bulb (76609):
- Beginning with the Smart Bulb turned on, power off the bulb.
- Wait 1 second, then power the Smart Bulb back on.
- Repeat steps 1 and 2 three more times.
- The bulb will flash twice to indicate successful reset.
Troubleshooting