Enroll, delete, or reset a Jasco In-Wall Smart Toggle Switch (14319/ZW4003)
The Jasco In-Wall Smart Toggle Switch (14319/ZW4003) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a Jasco In-Wall Smart Toggle Switch (14319/ZW4003), see Jasco In-Wall Smart Toggle Switch (14319/ZW4003) - Quick Start Guide.
To enroll a Jasco In-Wall Smart Toggle Switch into a Z-Wave network:
- Place the Z-Wave controller into Add Mode.
- Press up and release the switch toggle.
- Verify that the device shows up on the Alarm.com customer website or Alarm.com app and responds to commands to turn the device on/off.
To delete a Jasco In-Wall Smart Toggle Switch from a Z-Wave network:
- Place the Z-Wave controller into Delete Mode.
- Press up and release the switch toggle.
To reset a Jasco In-Wall Smart Toggle Switch:
- Quickly press up on the switch toggle three times, then immediately press down on the switch toggle three times.
- There will be no indication from the switch that a successful reset has occurred.