Enroll, delete, or reset a Jasco Enbrighten Z-Wave In-Wall Paddle Switch (76591)
The Jasco Enbrighten Z-Wave In-Wall Paddle Switch (76591) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a Jasco Enbrighten Z-Wave In-Wall Paddle Switch (76591), see Jasco Enbrighten Z-Wave In-Wall Paddle Switch (76591) - Installation Guide.
To enroll a Jasco Enbrighten Z-Wave In-Wall Paddle Switch (76591):
As a SmartStart/Long Range (LR) device:
It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices). This method also allows the device to utilize Z-Wave Long Range.
For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.
For more information about enrolling as a Z-Wave LR device, see Add a Z-Wave Long Range (Z-Wave LR) device.
As an S2 device:
If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.
For information about this process, see Add an S2-encrypted Z-Wave device.
As an S0 device:
If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.
- Place the Z-Wave controller into Add Mode.
- Press the top or bottom rocker.
To delete a Jasco Enbrighten Z-Wave In-Wall Paddle Switch (76591):
- Place the Z-Wave controller into Delete Mode.
- Press the top or bottom rocker.
To reset a Jasco Enbrighten Z-Wave In-Wall Paddle Switch (76591):
- Pull up the air gap switch.
- While pressing the bottom rocker, push in the air gap and continue pressing the bottom rocker. The LED will flash through the eight colors once.