Enroll, delete, or reset a Jasco Enbrighten Smart A19 LED Bulb (39723)
The Jasco Enbrighten Smart A19 LED Bulb (39723) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a Jasco Enbrighten Smart A19 LED Bulb (39723), see Jasco Enbrighten Smart A19 LED Bulb (39723) - Quick Start Guide.
To enroll a Jasco Enbrighten Smart A19 LED Bulb into a Z-Wave network:
- Place the Z-Wave controller into Add Mode.
- Apply power to the LED Smart Bulb.
- The LED Smart Bulb will be added to the network within 30 seconds, and the bulb will flash twice to signify a successful enrollment.
- Verify that the LED Smart Bulb shows up on the Alarm.com customer website and responds to commands to turn the LED Smart Bulb on/off.
To delete a Jasco Enbrighten Smart A19 LED Bulb from a Z-Wave network:
- Place the Z-Wave controller into Delete Mode.
- Apply power to the LED Smart Bulb.
- The LED Smart Bulb will flash twice to signify a successful deletion.
To reset a Jasco Enbrighten Smart A19 LED Bulb:
- Cycle power to the LED Smart Bulb four times within 4 seconds.
- The bulb will flash twice to signify a successful reset.