Enroll, delete, or reset a JascoPro In-Wall Dimmer (76596/76597)
The JascoPro Outdoor Plug-In Switch (76721/76722) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a Jasco Pro Series Smart LED Bulb (76609), see JascoPro Outdoor Plug-In Switch (76721/76722) - Installation Guide.
To enroll a JascoPro Outdoor Plug-In Switch (76721/76722):
As a SmartStart device:
It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).
For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.
As an S2 device:
If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.
For information about this process, see Add an S2-encrypted Z-Wave device.
As an S0 device:
If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.
- Place the Z-Wave controller into Add Mode.
-
Once the controller is ready to add your device, press the top or bottom of the rocker.
To delete a JascoPro Outdoor Plug-In Switch (76721/76722):
- Place the Z-Wave controller into Delete Mode.
-
Once the controller is ready to remove your device, press the top or bottom of the rocker.
To reset a JascoPro Outdoor Plug-In Switch (76721/76722):
-
Pull up the air gap switch.
-
While pressing the OFF (bottom) button, push in the air gap and continue pressing the OFF button. The LED flashes through the eight colors once.
Troubleshooting