Enroll, delete, or reset a JascoPro 700 Series In-Wall Toggle Dimmer (59384)
The JascoPro 700 Series In-Wall Toggle Dimmer (59384) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a JascoPro 700 Series In-Wall Toggle Dimmer (59384), see JascoPro 700 Series In-Wall Toggle Dimmer (59384) - Installation Guide.
To enroll a JascoPro 700 Series In-Wall Toggle Dimmer (59384):
As a SmartStart device:
It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).
For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.
As an S2 device:
If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.
For information about this process, see Add an S2-encrypted Z-Wave device.
As an S0 device:
If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.
- Place the Z-Wave controller into Add Mode.
- Press up and release the toggle.
To delete a JascoPro 700 Series In-Wall Toggle Dimmer (59384):
- Place the Z-Wave controller into Delete Mode.
- Press up and release the toggle.
To reset a JascoPro 700 Series In-Wall Toggle Dimmer (59384):
- Pull the airgap switch. Press and hold the bottom button, push the airgap switch in, and continue holding the bottom button for 10 seconds. The LED will flash each color once then stop to confirm.
Troubleshooting