Enroll, delete, or reset a GE Light Dimmer Module (45602)
The GE Light Dimmer Module (45602) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a GE Light Dimmer Module (45602), see GE Light Dimmer Module (45602) - Installation Guide.
To enroll a GE Light Dimmer Module into a Z-Wave network:
- Place the Z-Wave controller into Add Mode.
- Apply power to the device.
- Press the program button on the device.
- Verify that the device shows up on Alarm.com customer website or Alarm.com app and responds to commands to turn the device on/off.
To delete a GE Light Dimmer Module from a Z-Wave network:
- Place the Z-Wave controller into Delete Mode.
- Apply power to the device.
- Press the program button on the device.
To delete and reset a GE Light Dimmer Module:
- Press the top of the switch five times.
- Press and hold the bottom of the switch for 15 seconds.
- The LED will blink faster as the device is successfully reset.