Enroll, delete, or reset a GoControl Z-Wave In-Wall Switch (WS15Z5-1)
The GoControl Z-Wave In-Wall Switch (WS15Z5-1) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a GoControl Z-Wave In-Wall Switch (WS15Z5-1), see GoControl Z-Wave In-Wall Switch (WS15Z5-1) - Installation and User Guide.
To enroll a GoControl Z-Wave In-Wall Switch into a Z-Wave network:
- Place the Z-Wave controller into Add Mode.
- Tap the switch on the device. The device’s status LED will blink slowly.
- The status LED will stop blinking when the device has been successfully added.
- Verify that the device shows up on the Alarm.com customer website or Alarm.com app and responds to commands to turn the device on/off.
To delete a GoControl Z-Wave In-Wall Switch from a Z-Wave network:
- Place the Z-Wave controller into Delete Mode.
- Tap the switch two times.
- The status LED will blink slowly for 10 seconds to indicate a successful deletion.
To reset a GoControl Z-Wave In-Wall Switch:
- Tap the top of the switch paddle five times.
- Press and hold the bottom of the switch paddle for 15 seconds.
- The status LED will blink with increasing speed to indicate that the device is reset.