Enroll, delete, or reset a GoControl Smart LED Light Bulb (LB60Z-1)
The GoControl Smart LED Light Bulb (LB60Z-1) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a GoControl Smart LED Light Bulb (LB60Z-1), see GoControl Smart LED Light Bulb (LB60Z-1) - Installation Guide.
To enroll a GoControl Smart LED Light Bulb into a Z-Wave network:
- Place the Z-Wave controller into Add Mode.
- Apply power to the Smart LED Bulb.
- The Z-Wave controller should provide an indication that the device was added. The Smart LED Bulb will flash twice.
- Verify that the device shows up on the Alarm.com customer website or app and responds to commands to turn the Smart LED Bulb on/off.
- If the device is not successfully added, reset the bulb and repeat steps 1-4.
To delete a GoControl Smart LED Light Bulb from a Z-Wave network:
- Place the Z-Wave controller into Delete Mode.
- Apply power to the Smart LED Bulb.
- The Z-Wave controller should provide an indication that the device was removed.
- Reset the Smart LED Bulb.
To reset the GoControl Smart LED Light Bulb:
- Using a wall switch or manually plugging/unplugging the bulb, turn the power to the bulb off and then on four times within 4 seconds.
- The Smart LED Bulb will flash twice when the reset occurs.