Enroll, delete, or reset an EcoLink Z-Wave Plus Garage Controller (GDZW7-ECO)
The EcoLink Z-Wave Plus Garage Controller (GDZW7-ECO) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a EcoLink Z-Wave Plus Garage Controller (GDZW7-ECO), see EcoLink Z-Wave Plus Garage Controller (GDZW7-ECO) - Installation Guide.
To enroll a EcoLink Z-Wave Plus Garage Controller (GDZW7-ECO):
As a SmartStart device:
It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).
For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.
As an S2 device:
If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.
For information about this process, see Add an S2-encrypted Z-Wave device.
As an S0 device:
If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.
- Place the Z-Wave controller into Add Mode.
- Press the Hub button on the EcoLink device.
- The device will beep and its status light will illuminate green to indicate successful enrollment.
To delete a EcoLink Z-Wave Plus Garage Controller (GDZW7-ECO):
- Place the Z-Wave controller into Delete Mode.
- Press the Hub button on the EcoLink device.
- The device will beep three times and the status light will flash red to indicate a successful deletion.
To reset a EcoLink Z-Wave Plus Garage Controller (GDZW7-ECO):
Note: Factory reset only works when the device is already added into a Z-Wave network. If the device is not included in a network, then it cannot be factory reset.
- Insert a paperclip into the reset button hole until the button depresses. There will be a short beep.
- Hold the button down for 10 seconds. The status light will blink red while the reset button is pressed and will go out after 10 seconds.
- The device’s status light will turn green to indicate the reset operation is complete.