PoE to Wi-Fi Bridge (ADC-W110) - Data Sheet
Introduction
The ADC-W110 makes it easy to install any Alarm.com Power over Ethernet (PoE) camera, eliminating the need to run cable wiring throughout a home or business.
Simply plug the device into a wall outlet to provide a PoE camera with both electrical power and secure, reliable Wi-Fi connectivity.
The ADC-W110 integrates with Alarm.com, providing easy post-installation troubleshooting and enhanced security.
Features
- Simple plug-in installation
- Secure, reliable Wi-Fi connectivity
- Eliminate the need for wires
Requirements
| Power | Standard electrical outlet |
|---|---|
| Network | Broadband Internet connection with router |
| Setup | Access Point (AP) mode or Wi-Fi Protect Setup (WPS) mode |
Specifications
| Wi-Fi Security | WEP, WPA, WPA2 Wi-Fi |
|---|---|
| Ethernet Interface | 10 / 100 Mbps RJ-45 IEEE 802.3 af PoE |
| Wireless | IEEE 802.11 b / g / n 2.4 GHz |
| Dimensions (W x L x H) | 2.4 x 2.2 x 3.6" |
| Operating Temperature | 32°F - 113°F (0°C - 45°C) |
| Operating Humidity | < 90% |
| Operating Voltage | Min: 100 V, Max: 120 V |
LED Guide
Power 
| LED status | Description |
|---|---|
|
Solid green
|
Powered on |
|
Off
|
Powered down |
Status 
Note: The status of the ADC-W110 uses two LEDs instead of one. Both LED patterns are required to determine the status.
 LED status |
 LED status |
Description |
|---|---|---|
|
Solid white
|
Solid green
|
Successfully connected to the wireless network |
|
Solid white
|
Blinking green
|
Local network connection only, connecting to internet |
|
Off
|
Blinking green
|
WPS mode |
|
Blinking white
|
Off
|
AP mode |
|
Blinking red
|
Off
|
No network found |
|
Blinking red
|
Blinking red
|
Restore factory default settings |
