PoE to Wi-Fi Bridge (ADC-W100) - Data Sheet
Introduction
The ADC-W100 makes it easy to install any Alarm.com Power over Ethernet (PoE) camera by eliminating the need to run cable wiring throughout a home or business. The ADC-W100 plugs into any wall outlet and provides the PoE camera with both electrical power and secure, reliable Wi-Fi connectivity.
Specifications
| Ethernet Interface | 10/100 Ethernet |
|---|---|
| Wi-Fi | IEEE 802.11 b/g/n single band WLAN |
| Power over Ethernet |
IEEE 802.3AF |
| Wi-Fi Security | WEP, WPA, WPA2 |
| Dimensions | 3 x 4.5 x 1.7'' (75.7 x 113.5 x 43.1 mm) |
| Operating temperature | 0° to 40° C |
Note: The power output of the ADC-W100 adjusts to the needs of the connected video device based on the IEEE 802.3AF standard. For more information about Power over Ethernet (PoE) standards and how they relate to Alarm.com video devices, see How does Power-over-Ethernet (PoE) work with Alarm.com video devices?.
Button description
| Button | Description |
|---|---|
| WPS | To pair with a router via WPS (Press and hold for 3 seconds) |
| Reset | Reset to Factory Default (press and hold 10 seconds) |
LED descriptions
Power
| LED Status | Description |
|---|---|
|
Off
|
Power off |
|
Solid green
|
Power on |
WLAN
| LED Status | Description |
|---|---|
|
Off
|
Wi-Fi not in use |
|
Solid green
|
Wi-Fi connected |
|
Blinking green
|
Data is being sent over Wi-Fi |
|
Solid red
|
Wi-Fi connecting or connection failed |
|
Blinking red
|
WPS pairing process |
|
Blinking orange
|
Weak Wi-Fi signal |
|
Blinking red and green
|
Poor Wi-Fi connectivity |
Data
| LED Status | Description |
|---|---|
|
Off
|
No data transmission on data port |
|
Blinking green
|
Data is being sent over data port |
Camera
| LED status | Description |
|---|---|
|
Off
|
No camera detected on the camera port |
|
Blinking green
|
Camera is connected to the port Note: It is common to see the Camera LED go between a solid green and a quick rapid flicker/blink. This is expected behavior. |