Factory reset an ADC-W114C to its default settings
Important: Wait at least two minutes for the access point to power on fully before performing the following procedure. The factory reset might fail if the device is still powering on.
| Reset procedure | Reset button location | Reset button image |
|---|---|---|
|
Press and hold the Reset button (pinhole) for 12 to 15 seconds, or until the status LED begins blinking red and green, then release the button. Caution: This process will restore factory-default settings to the device. All network configurations will be deleted and all connected devices will need to be reconnected. |
The Reset button is located in the pinhole directly below the antenna, on the right-hand side of the front of the device. |
|
Important: Once the access point has been reset, it is normal for the LED to turn off momentarily. It is best to leave the access point plugged into power and undisturbed for two minutes after performing the factory reset.