Factory reset an ADC-W115C to its default settings

Last updated
Save as PDF

Resetting a video device to its factory defaults removes all programming from the device.

Important: Wait at least two minutes for the video device to power on fully before performing the following procedure. The factory reset might fail if the device is still powering on.

Reset procedure	Reset button location	Reset button image
Press and hold the Reset button (pinhole) for 15 to 20 seconds (use a paper clip or tool if necessary). All LEDs will blink simultaneously to indicate that the device will reset. Caution: This will restore factory-default settings to the device. All network configurations will be deleted and all connected devices will need to be reconnected using WPS mode.	The pinhole directly below the antenna on the right-hand side of the device (while looking at the front of the device).	Reset button

Reset procedure

Reset button location

Reset button image

Press and hold the Reset button (pinhole) for 15 to 20 seconds (use a paper clip or tool if necessary). All LEDs will blink simultaneously to indicate that the device will reset.

Caution: This will restore factory-default settings to the device. All network configurations will be deleted and all connected devices will need to be reconnected using WPS mode.

The pinhole directly below the antenna on the right-hand side of the device (while looking at the front of the device).

ADC-W115C front and side.png

Reset button

Important: Once a video device has been reset, it is normal for the LED to turn off momentarily. It is best to leave the video device plugged into power and undisturbed for two minutes after performing the factory reset.