What are the DIP switches used for on an X1100 Door Controller?
The four DIP switches configure the operating mode. DIP switches are read on power-up except where noted.
By default, the DIP switches on the X1100 door controller come pre-set in the OFF position required for normal operation.
All OFF
1 and 2 ON, 3 and 4 OFF
Note: Pressing the reset switch S2 causes a reboot.
DIP switches
The dip switches on the X1100 door controller are designed to be in the OFF position during all standard operations. These dip switches should only be turned on at the request of support or during the following specific procedures:
- Perform a factory reset on an X1100 door controller. For more information, see To perform a Factory Reset on an ADC-AC-X1100 controller.
- Configure a static IP. For more information, see Configure an Access Control door controller to use a Static IP.